Just starting with Zephyr

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • cam3d
    replied
    LarryForehand Here's a useful guide: https://www.3dflow.net/technology/do...for-turntable/

    Note: What kind of camera are you taking those pictures with? The image quality is pretty bad so you'll have a hard time reconstructing anything with those images.

    Leave a comment:


  • LarryForehand
    started a topic Just starting with Zephyr

    Just starting with Zephyr

    Just beginning with Zephyr. Would like to eventually print this impossible to find trim piece for an old jaguar. Would someone perhaps give me an outline of steps to make a 3D photo model in Zephyr? Number of photos, angles, size references etc. Also, as you see there is one "clip" broken from this piece. Is it possible at some point to "copy and move" the good clip remaining to the broken area? I know all of this requires skills that I have not developed yet, but what I'm looking for at present is just a roadmap to begin to follow.
Working...