If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Optimizing Thin Meshes Welcome to the 3DF Zephyr tutorial series. In this recipe, you will learn how to optimize the 3DF Zephyr settings for difficult subject with a thin geometry, such as leaves and other similar surfaces. Introduction Depending on the … Read More
Hello, I'm Chris from Germany. Unfortunately I have a problem with the program. I want to make a copy of an item. However, the item has holes. I've tried different backgrounds or lighting. However, the holes remain in the copy. I hope you can help me.?
Leave a comment: