3DF Zephyr Forum - English - 3Dflow.net forum

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

	Topics		Statistics	Last Post
	Closed, Sticky: 3Dflow Discord channel by 3Dflow Started by 3Dflow, 2018-06-26, 11:47 AM		0 responses 599 views 0 likes	Last Post by 3Dflow 2018-06-26, 11:47 AM
	Low quality of 3d model created by 3d zephyr in other software by AbbasA Started by AbbasA, 2021-03-03, 09:38 PM		2 responses 53 views 0 likes	Last Post by AbbasA 2021-03-04, 03:31 PM
	How do I re-run a reconstruction attempt? by gneisslab Started by gneisslab, 2021-02-28, 04:40 PM		2 responses 32 views 0 likes	Last Post by gneisslab 2021-03-01, 02:56 PM
	Measure object area by AbbasA Started by AbbasA, 2021-02-23, 09:10 PM		4 responses 34 views 0 likes	Last Post by AbbasA 2021-03-01, 02:29 PM
	model sharpening tools? by roger johnson Started by roger johnson, 2021-02-26, 10:17 AM		6 responses 55 views 0 likes	Last Post by roger johnson 2021-03-01, 11:44 AM
	Texture Creation uses the C drive when writing cache by jacopovolto Started by jacopovolto, 2021-02-26, 04:28 PM		1 response 36 views 0 likes	Last Post by cam3d 2021-02-28, 11:07 PM
	structured light question by schorle Started by schorle, 2019-06-28, 08:56 PM		3 responses 170 views 0 likes	Last Post by cam3d 2021-02-24, 02:40 AM
	Question regarding "Inclination" of a line and fit a plane using "Triangle" by AbbasA Started by AbbasA, 2021-02-19, 10:35 PM		2 responses 28 views 0 likes	Last Post by AbbasA 2021-02-22, 08:08 PM
	Advice for noob scanning by morepolys Started by morepolys, 2021-02-15, 03:35 PM		5 responses 87 views 0 likes	Last Post by cam3d 2021-02-21, 09:04 PM
	Lite Version Editing Capability by Hammer Started by Hammer, 2021-02-20, 09:32 PM		1 response 37 views 0 likes	Last Post by cam3d 2021-02-21, 08:32 PM
	Photoconsistency Pass takes way too long by jacopovolto Started by jacopovolto, 2021-02-17, 12:09 PM		4 responses 44 views 0 likes	Last Post by cam3d 2021-02-18, 10:55 PM

Previous 1 2 3 4 5 6 13 53 73 template Next

No topics found.

Mark This Channel Read

Working...

X